Goodman-mfg Seer "m" series PG 15 User Manual

Goodman Manufacturing Company, L.P.5151 San Felipe, Suite 500, Houston, TX 77056www.goodmanmfg.com© 2006 - 2009, 2012 Goodman Manufacturing Company, L

10UNIT VOLTAGEThe unit transformer is factory connected for 230V operation.If the unit is to operate on 208V, reconnect the transformerprimary lead as

11All ductwork exposed to the outdoors must include a weatherproofbarrier and adequate insulation.A duct system should be installed in accordance with

12NORMAL SEQUENCES OF OPERATIONHEATINGThis unit is equipped with an ignition control that automaticallylights the main burner. DO NOT attempt to ligh

13If the power to the unit is interrupted during the heating cycle, itmay cause the secondary limit to trip. Once the blowercompartment temperature dr

14With a properly designed system, the proper amount oftemperature rise will normally be obtained when the unit isoperated at rated input with the rec

15space. It is the installing contractors responsibility to ensurethe proper refrigerant sub-cooling at the condenser is adjustedfor each application.

16ABNORMAL O PERATION - HEATINGINTERNAL C ONTROL F AILUREIf the integrated ignition control in this unit encounters aninternal fault, it will go into

17NOTE: Some electronic thermostats also have a built-incompressor short cycle timer that may be longer than thethree minute delay given above. If

18MAIN BURNER FLAME (QUALIFIED SERVICER ONLY)Flames should be stable, soft and blue (dust may causeorange tips but must not be yellow). The flames mus

19APPENDIX

2INDEXREPLACEMENT PARTS ...

20HEATING TIMING CHARTCOOLING TIMING CHARTRed Light Signal Refer to Abnormal Heating or Cooling Operation Sections of this ManualOff Internal Control

21COMBUSTIONAIR INTAKEEXHAUST FLUE HOODCONTROL WIRE ENTRANCEPOWER WIRE ENTRANCE7 7/87 5/16SUCTION/LIQUID PRESSURE PORTSBEHIND COMPRESSOR ACCESS PANELH

22*PG15*****41A* WIRING DIAGRAMHIGH VOLTAGE! D ALL .M. F.ISCONNECT POWER BEFORE SERVICINGULTIPLE POWER SOURCES MAY BE PRESENT AILURE TO DOSO MAY CAU

23*PG15*****41A* WIRING DIAGRAMHIGH VOLTAGE! D ALL .M. F.ISCONNECT POWER BEFORE SERVICINGULTIPLE POWER SOURCES MAY BE PRESENT AILURE TO DOSO MAY CAU

24HIGH VOLTAGE! D ALL .M. F.ISCONNECT POWER BEFORE SERVICINGULTIPLE POWER SOURCES MAY BE PRESENT AILURE TO DOSO MAY CAUSE PROPERTY DAMAGE, PERSONAL

25HIGH VOLTAGE! D ALL .M. F.ISCONNECT POWER BEFORE SERVICINGULTIPLE POWER SOURCES MAY BE PRESENT AILURE TO DOSO MAY CAUSE PROPERTY DAMAGE, PERSONAL

26-NOTE: Roof overhang should be no more than 36".3"MIN12" MIN12" MIN 36" MIN(FOR SERVICE).48" MINMINIMUM CLEARANCESRECO

27BLOWER PERFORMANCE DATAX = Outside of Temperature Rise Range - Not Recommended.NOTE: The shaded area indicates ranges in excess of maximum external

28PACKAGE UNITS - DUAL FUEL & GASHOMEOWNER’S ROUTINE MAINTENANCE RECOMMENDATIONSWe strongly recommend a bi-annual maintenance checkup be perfor

3MAINTENANCE ...

4REPLACEMENT PARTSORDERING P ARTSWhen reporting shortages or damages, or ordering repairparts, give the complete unit model and serial numbers asstamp

5 CARBON MONOXIDE POISONING HAZARD B10259-216 Carbon monoxide producing devices (such as an automobile, space heater, gas water heater, et

6Rooftop Installation• The unit may be installed directly on wood floors or onClass A, Class B, or Class C roof covering material.• To avoid possible

7RIGGING DETAILSIMPORTANT NOTE: If using bottom discharge with roof curb,ductwork should be attached to the curb prior to installing theunit. Ductwork

88. The unit must be connected to the building piping by oneof the following methods:• Rigid metallic pipe and fittings• Semirigid metallic tubing an

9cooling. Units which will have economizers may use thermostatswith two or three stages of cooling. All units can use single stageor multi-stage therm